Trimlux Reg 25
Installation Strategy:
The step by step installation method we promote is focused on clearly explaining a series of simple tasks that will result in a competent installation and maximise the long term benefits of our product. Seals are about leak prevention – not speed of installation.
Installation Technique
By applying separate lines of Sealux-N into the strip (step 7) and onto the ledge (step 9) and fusing both together (step 10), we ensure a continuous watertight seal is established between the ledge and strip.
Installation Instructions: Trimlux Reg 25
Click on images for enlarged view.
2 At mitre cuts – Snip inner leg off (square) as shown.
3 At end cuts – Snip inner leg off (at angle) as shown.
4 Carefully remove the frays left at saw cut edges.
5 Dry fit to check. If outer strip edge does not rest on ledge, bend the first 50mm of the “Removeable leg” back and forth to weaken and tear off the remainder.
6 Wipe ledge with alcohol or methylated spirits.
7 Commence installation with middle strip (if any). Insert strip upside down in Mitre Box and support remainder of strip steady. Cut Sealant Nozzle to Expose 4mm Diameter hole. Resting nozzle on inner leg, lay a line of Sealux-N 400mm in strip (7a). Level Sealux-N across width of inner leg with spatula (7b). Continue in steps of 400mm till complete. Do not be afraid to redistribute Sealux-N as required.
8 Butter Sealux-N across mitre cuts and end cuts, leaving slightly proud on each.
9 Using finger under nozzle as a support and fingertip against wall as a guide, lay a line Sealux-N on the ledge. Lay a line of Sealux-N on wall roughly 15mm over ledge (no guide required).
10 Lay Sealux-N on wall as shown. Rotate strip into position over ledge, fusing the Sealux-N in strip with Sealux-N on ledge.
11 Remove excess silicone (if any) on ledge with spatula.
12 Ensure Sealux-N fuses across strips at corners.
